Is the correct depth for my tire’s tread depth really to the top of Abe Lincoln head on a penny?
■ Answer: Very close, yes, but there are other factors to consider. In (Minnesota state statutes) we read that a tire shall be considered unsafe if it has any part of the ply or cord exposed; or any bulge, bump or separation; or a tread design depth of less than 2/32 (1/16) of an inch measured in the tread groove nearest the center of the tire at three locations equally spaced around the circumference of the tire. If you look at a ruler you will be amazed how little 1/16 of an inch is.
Also, a tire is unsafe if it is marked “not for highway use,” “for racing purposes only” or “unsafe for highways use”. Additionally, if the tire tread or sidewalls have any cracks, cuts or snags deep enough to expose the body cords or was re-cut or re-grooved below the original tread design depth, the tire is considered unsafe. Remember to keep your tires inflated to the vehicle manufacture’s recommended tire pressure. This insures that the most tire surface is on the roadway and that the tire does not become convex or concave, again, reducing contact with the roadway. Thanks for asking.